Solar Project Block Diagram

Objective:

1. To learn the Solar power supply working.
2. To understand flow of the operation
3. To learn the input and output of the project

Figure: this figure shown the block diagram of solar power

Procedure/Description:

Block Diagram Operation

·         1. HEAT FROM SUNLIGHT

The heat from the sun that heat up the solar plate

·        2.  SOLAR CELL

Solar cell will receive the heat from the sun trough the solar plate and change the heat into electrical source

·         3. CAPACITORS

 Capacitor will store the electrical charge from the solar plate

·         4. SUPPLY

The charge from the capacitor that has been stored in capacitor will be use as supply for the output.

Result and Analysis:

1. Sunlight the main source to generate the electric supply.
2. the size of the solar plate cause the size of the voltage.

Week 4

Week 4

Title of activities: Designing the PCB layout using Proteus 2 software

Objective:

·         To construct the solar circuit in the PCB layout  using the Proteus Software

·         To make it the circuit compact

·         To learn how to produce the good PCB using the software by arranging all the wire properly.

Content/procedure:

·         The circuit construct following the circuit given

·         The circuit has been done convert to the PCB

 

·         the component find in the software library part by part

·         Do the connection for every component by referring the project schematic that given in  the magazine

·         Label all the components and put the recommended value of each component

·         After finish connecting the wire of every component, convert the schematic to PCB layout and do arrangement to the component. The wire must be arrange in a right arrangement to prevent the error connection of PCB

·         Print out PCB layout on transparent paper

Result and analysis:

·         The PCB layout is done

·         The reason for why we designing the PCB layout are for the circuit is to produce the PCB to install the component of the project.

Conclusion:

·         After finish this week of activities, we are able to produce the PCB layout by using the software and print it out before we proceed to next step that is do the etching .